Sauber C9 Rear Wing Set Assembly Guide: Deburr with cutter knife if needed.Tighten Screws Slowly! Use the black screws to build the wing. Take double sided adhesive tape to fix the wing to the body. Align the wing at the body into right position, Then drill two holes with 1.8mm drill bit into the back […]
Mazda 787 Rear Wing Set Assembly Guide: Deburr with cutter knife if needed.Tighten Screws Slowly! Use the black screws to build the wing. Take double sided adhesive tape to fix the wing to the body. Align the wing at the body into right position, Then drill two holes with 1.8mm drill bit into the back […]
Toyota GT 1 Assembly guide: Deburr parts with cutter knife if needed Upper wing hole is 1mm! Drill up holes, recommended is 1.5mm for screw M2x5mm Parts are paintable Screws needed: 4 x M2x5mm 2 x M2x4mm metric fine thread head sink with nut For fixing side plates on body ending
GLF Set Assembly Guide: Rear Wing: Deburr with cutter knife if needed Upper wing hole size is 1.5mm! M2x5mm screws recommended Use original GLF screw to fix wing to chassis Tail-Light from RC92HK-Shop is useable Parts are paintable 1 x upper wing ending in 60 degrees 1 x upper wing ending in […]